Skip to main content

Building Comforts

Building Comforts is a trusted provider of waterproofing, heat proofing, and construction chemical solutions in Pakistan.

Contact Info

  • Office No. 4, Plot 40-C, 12th St, D.H.A Phase 6, Nishat Commercial Area, Lane Ph-6, Defence, Karachi, 75500
  • info@buildingcomforts.com
Product

QIS FLEXER HALF

A two-component, semi-elastic cement and acrylic polymer waterproofing mortar for balconies, wet areas and mineral surfaces beneath screed or ceramic finishes.

QIS FLEXER HALF
Roof Waterproofing

QIS FLEXER HALF

Forms an integrated waterproofing coating on the treated structure

QIS FLEXER HALF is a polymer-reinforced, non-shrink waterproofing mortar based on cement and acrylic polymer. Its two-component formulation forms a semi-elastic coating that bonds strongly to concrete, screed, mosaic and similar mineral substrates while allowing the structure to breathe. Suitable for horizontal and vertical surfaces indoors and outdoors, it provides waterproofing beneath screed and ceramic finishes in balconies and wet areas. It can be applied to damp substrates and resists freezing and thawing once completely dry.

  • Waterproofing beneath screed and ceramic finishes in balconies and wet areas.
  • Interior and exterior mineral surfaces, including facades.
Product Details

Application & Performance

QIS ACRIMAX UV applied on a roof

How It's Applied

Clean the surface of dust, oil, paint and curing compounds, roughen it, and pre-wet it until damp with no standing water. Mix component A (powder) into component B (liquid) while stirring for 4 to 5 minutes, rest 5 minutes, then remix for 3 minutes, and use within 1 hour at +20°C. Brush onto the concrete to about 2 mm total thickness, adding elastic mesh between layers if needed. Apply only between +5°C and +35°C, and protect from rain and frost for at least 24 hours. Final strength is reached after 28 days.

  • Total consumption2.5–3.0 kg/m² at approximately 2 mm thickness
  • First layer1.60 kg/m²
  • Second Layer1.40 kg/m²
QIS ACRIMAX UV close-up application

Technical Data

TDS values are stated at +20°C and 50% relative humidity unless otherwise indicated. Higher temperatures shorten working and setting times; lower temperatures extend them.

  • Substrate application temperature+5°C to +35°C
  • Service temperature−20°C to +80°C
  • Adhesion to concrete>1.5 N/mm²
  • Working time1 hour at +20°C and 50% relative humidity
  • Density1.65 ± 0.05 kg/L
  • Positive water pressure resistance5 bar

    PRODUCT INQUIRY

    Request a Quote

    Tell us about your requirements and our team will get back to you with the right product information and pricing.











    Optional. JPG, PNG, PDF or DOC files up to 10 MB.