FIS EM Plus 390s
A high-performance epoxy anchoring mortar for engineered fixings and post-installed reinforcement in concrete.
FIS EM Plus 390s
Cracked and non-cracked concrete applications
Fischer FIS EM Plus is a two-component epoxy injection mortar used with approved anchor rods or reinforcing bars. The 390 S cartridge mixes resin and hardener through a static mixer, creating a bonded anchorage in the prepared drill hole. It is suitable for cracked and non-cracked concrete within its assessment.
- Structural steel fixings
- Post-installed rebar
- Heavy shelving and equipment
- Engineered roof or solar-support anchorage
Application & Performance
Application Method
Use for rebar connections and structural anchorings. Clean the hole with the blow, brush, blow sequence, twice each (hollow drilling is exempt), mix through the static mixer and inject bubble-free from the hole base. Observe the temperature-dependent curing times, and double them in wet concrete or water-filled holes, before tightening the fixing.
- Rebar connectionsPost-installed rebar connections
- Structural fixingsHeavy steel constructions, silos, tall shelving and sound barriers
- Special drill holesDiamond-drilled or water-filled holes
- Installation typeFIS A: pre-positioned and push-through; RG M I: pre-positioned
- Hole cleaningBlow, brush, blow, twice each
- CuringDouble the time in wet concrete or water-filled holes
Technical Data
FIS EM Plus is an epoxy mortar for cracked and non-cracked concrete. The 390 S pack contains a 390 ml cartridge and two FIS MR Plus mixers, and supports rebar diameters of 8 to 40 mm with processing down to -5 °C. Load capacities are configuration-specific; refer to the load tables and ETA-17/0979.
- Product typeTwo-component epoxy injection mortar
- Pack contents1 × 390 ml cartridge and 2 × FIS MR Plus static mixers
- Concrete gradesC20/25 to C50/60, cracked and non-cracked
- Rebar diameter8 to 40 mm, including seismic applications
- Low-temperature processingDown to -5 °C
- ETA referencesETA-17/0979 for concrete; ETA-17/1056 for post-installed rebar