Skip to main content

Building Comforts

Building Comforts is a trusted provider of waterproofing, heat proofing, and construction chemical solutions in Pakistan.

Contact Info

  • Office No. 4, Plot 40-C, 12th St, D.H.A Phase 6, Nishat Commercial Area, Lane Ph-6, Defence, Karachi, 75500
  • info@buildingcomforts.com
Product

Mapei 88

A rigid cementitious waterproofing mortar for sound concrete and masonry in basements, tanks and wet areas.

Mapei 88
Cementitious waterproofing

Mapei 88

Single-component powder

Download TDS

Planiseal 88 is a single-component osmotic mortar mixed with water and applied by brush, trowel or spray. It provides rigid waterproofing for stable mineral substrates, including negative-side basement work and water-retaining structures. It is unsuitable for flexible or unstable substrates.

  • Basement and foundation walls
  • Lift pits
  • Water tanks
  • Pools and water features
Product Details

Application & Performance

Application Method

Prepare a sound, clean surface, seal active leaks and remove standing water. Slowly add one 25 kg bag to 5.25 to 5.75 L of potable water, mix at 300 to 500 rpm for 2 to 3 minutes, rest for 10 minutes, then remix for 1 minute. Apply 2 to 3 coats by brush, or by trowel or spray, to about 2 to 3 mm total thickness, recoating within 24 hours. Allow 7 days before putting it into service.

  • Mixing25 kg bag to 5.25 to 5.75 L potable water
  • ApplicationBrush, trowel or spray
  • ThicknessAbout 2 to 3 mm total; 1.5 kg/m² per mm
  • RecoatingAfter 5 to 6 hours, within 24 hours
  • Working conditions+5 to +40 °C; pot life about 1 hour at +20 °C
  • ServiceWait 7 days before use

Technical Data

Planiseal 88 is a single-component, normal-setting osmotic cementitious mortar that forms a rigid waterproof coating suitable for contact with drinking water. At 28 days, compressive strength exceeds 25 MPa and bond strength on concrete exceeds 2 MPa.

  • CompositionCement-based compound, graded aggregates and synthetic polymers
  • Form and colourGrey or white powder; fluid, trowelable mortar
  • Maximum aggregate size0.4 mm
  • Bulk density / mixed density1,300 kg/m³ / 1,800 kg/m³
  • Dry solids100%
  • Mixing ratio100 parts powder to 21 to 23 parts water
  • Service temperature+5 to +90 °C

For further information, refer to the Technical Data Sheet (TDS)

    PRODUCT INQUIRY

    Request a Quote

    Tell us about your requirements and our team will get back to you with the right product information and pricing.











    Optional. JPG, PNG, PDF or DOC files up to 10 MB.